Janet

The wiring harness connects various electrical components and can be replaced in the unlikely event it is damaged or determined to be non-functional by Rad Power Bikes Product Support.  The wiring ...

This guide will show you how to remove and reinstall the rear wheel on a RadCity. The photos below show a 2018 RadCity, but the process will be similar for most RadCity models. Tools Needed: Woode...

The headset of your bike is located inside the headtube and allows the fork steering column and front wheel to rotate and turn. The headset can loosen over time with normal use, so it is important ...

The RadCity controller can be replaced if you are instructed to do so by Rad Power Bikes Product Support. Watch the video and follow the instructions below to replace the controller on your RadCity...

The RadCity wiring harness runs through the downtube and connects various electrical components to the controller. The wiring harness can be replaced if you are instructed to do so by Rad Power Bik...

The pedal assist (PAS) sensor is designed to be replaced in the unlikely event it is damaged or determined to be non-functional by Rad Power Bikes Product Support. The video and instructions below...

In the unlikely event that your bike won't turn on, this guide will help troubleshoot the issue so you can get back to riding Rad as soon as possible! This guide uses a 2019 RadCity Step-Thru but t...

When the Pedal Assist Level is set to greater than 0 and a rider is pedaling, a magnet ring near the bottom bracket sends a signal to the pedal assist (PAS) sensor to deliver power assistance to th...

This article will show you (or your bike mechanic) how to test for adequate stem clamp tightness with a handlebar twist test. Performing a handlebar twist test is an important safety check to make ...

In the unlikely event the cranks on your bike are damaged or non-functioning, they can be replaced using the steps below. This article shows a crank replacement on a RadCity Step-Thru 2, but the st...