Janet

To troubleshoot an "Error 30" message on a RadWagon, perform a connector check to ensure all connectors are secure and in good condition. This guide uses a 2019 RadWagon but the steps will be simil...

The headset of your bike is located inside the headtube and allows the fork steering column and front wheel to rotate and turn. The headset can loosen over time with normal use, so it is important ...

The headset of your bike is located inside the headtube and allows the fork steering column and front wheel to rotate and turn. The headset can loosen over time with normal use, so it is important ...

The wiring harness is a component made of wires that connects the electrical components on your ebike. On the RadWagon, the wiring harness can be found at the front of the bike and runs through the...

The RadWagon 4 comes with an adjustable handlebar stem that can be adjusted to comfortably fit any rider. Over time and with normal use, the handlebar stem lever may need to be adjusted if the mech...

The RadWagon 4 kickstand springs can be replaced if needed after wearing out with normal use over time, or in the unlikely event they are damaged or determined to be non-functional by Rad Power Bik...

This guide will show you how to remove and reinstall the rear wheel on a RadRunner. This guide uses a RadRunner 1, but the steps will be similar for a RadRunner Plus. Tools Needed: Wooden blocks ...

Checking the connectors and ensuring they are secure and undamaged can help diagnose electrical issues and make sure your ebike is safe and fun to ride. Over time, a connector on your ebike may vib...

The pedal assist (PAS) sensor is designed to be replaced in the unlikely event it is damaged or determined to be non-functional by Rad Power Bikes Product Support. The video and instructions below ...

The wiring harness connects various electrical components on the bike and can be replaced in the unlikely event it is damaged or determined to be non-functional by Rad Power Bikes Product Support. ...